IPv6 suddenly not working (ERL-3, TWC)
Hello, IPv6 was fully working on my router (ERL-3) with dhcpv6-pd. I also had ICMP working as well, but that suddenly stopped working as well without any known reason. I updated to 1.8.5, but IPv6 was...
View ArticleIPsec L2TP issues
Hey guys,I have been working on this for quite a few days and I am all out of ideas. I have followed Ubiquiti's guides and some from other websites. I have been trying to use the vpn logs. I have also...
View ArticleHow do I stop this kind of traffic?
I'm a SOHO user of Edge Router Lite and I'm getting hundreds of PC's connecting to my router. I realize it's probably some sort of botnet attack. My firewall is setup as a basic stateful firewall. Drop...
View ArticleEdge Router Lite - ETH1 10/100
Hello, I am new to Ubquiti - Love it but having some difficutlies, Anyway I configure the router ETH1 is always 10/100 where ETH0 & ETH1 are 100/1000 Any suggestions on how I can overcome this? I...
View ArticleClik here to view.
VoIP - General Question on QoS
We've had a few clients off different access points reporting issues with their VoIP quality recently, dropped words or static and there doesnt' seem to be an obvious cause. Our initial investigation...
View ArticleClik here to view.
Routing between multiple external IP's
Hi Guys, Ive got a bit of a challenge here! I've got an external IP range and have different LANs. 80.xxx.xxx.25 goes to eth1 which is main network, 80.xxx.xxx.30 goes to eth3 which is my web server...
View ArticleFirewall rules and port forwarding.
Hi all, I have a question here. If I port forward port 22 to my server but I have a drop SSH and port 22 rule in WAN_IN, will my connection with my server interrupted when I'm connected from outside?...
View ArticleEdgmax Slow saving changes
Please help! I am using a poe with v1.8.5 Saving changes (ie static map of ip) takes 5 minutes. Is that normal?
View ArticleIPSEC Redundant VPN - Possible?
Hello all, I do not yet have an Edgerouter product but am exploring if this product line can suit my needs, so I would like to seek your expertise on this matter (currently looking at the Edgerouter 5...
View ArticleOptions for a bricked ER-X
Hello So I was updating the ER-X from 1.8.0 to 1.8.5 thourgh the web interface. I got the "Upload failed" response on two consecutive attempts. Afterwards, I rebooted the router as recommended on some...
View ArticleRouting/Restrictions on EdgeRouter
Hi Guys i'm desperately :-) I have an home lan with a fritzbox, an EDGEMax Router and an EDGEMax Switch. on the Fritzbox i configured DHCP, Internet and 3 VPN Accounts how can connect to home lan...
View ArticleHow do I block IP address through VNP
Hello, I have a remote office that I need to block a group of IP addresses at my HQ site. Access is via IPSEC vpn. I have found a few posts on how to block IP addresses....but I still can not...
View ArticleClik here to view.
No Internet on EdgeRouter X SFP
Hello all,I'm new to Ubiquiti and a novice at routers, so please be gentle .I just purchased the EdgeRouter X SFP to replace a older (failing) TP-Link router. I installed a Unifi AP AC LR a few weeks...
View ArticleERL 1.8.5 DHCP PPPoE over GPON not receiving DNS servers
Hi, As mentioned in subject, I have a PPPoE connection over GPON, and it is not getting the DNS servers, even though it received the IP just fine. Config: firewall { all-ping enable broadcast-ping...
View ArticleSpurious traffic?
I am running EdgeRouter.ER-e100.v1.8.0.4853089.160219.1607, and seeing an awfully large amount of traffic transmitted on my eth1 to the LAN side of my network, completely unrelated to the traffic...
View ArticleER-X SFP v1.8.5 can't enable "HW NAT" offload
Hi, ER-X SFP upgrade to v1.8.5: Linux ubnt 3.10.14-UBNT #1 SMP Sat May 28 09:48:10 PDT 2016 mipsWelcome to EdgeOS ubnt@ubnt:~$ show versionVersion: v1.8.5Build ID: 4884695Build on: 06/08/16...
View ArticleIssue with Tagged VLAN Route
Hi Everyone, I have an EdgeRouter Pro, running 1.8.0 that has been working great for the longest time. Recently, I changed uplink method, and I'm experiencing problems. Here is the quick and dirty...
View ArticleEdgeRouter Dual IPV6 Possibly bugged?
So... I have dual WAN connections (ATT FTTH, XFinity), and both of them offer native ipv6. On the att wan interface i am using dhcpv6 and it gets the address. One the xfinity interface, it is unable...
View ArticleCan the edgerouter x be an vpn server?
Greetings, is the edgerouter a vpn server? Can I make wifi users from a Unifi AP Lite start a VPN connection with the edgerouter as an extra layer of security or do I need a separate server? The edge's...
View ArticleClik here to view.
VLAN offload on ER Pro 1.8.5
I have an ER Pro running 1.8.5.Its CPU utilization has been high, so I tried to enable VLAN offloading since the internet connection is via VLAN 15 on eth1.It didn't seem to make a difference in CPU...
View Article