Clik here to view.
OpenVPN Firewall rule order
I have setup 2 edge routers using VPN and I have added a rule for OpenVPN to pass traffic between LAN'sDoes this rule need to be at the top to work properly. Thanks for any info you can provide me.
View ArticleERL + ERPro + Interface tunnel GRE and OSPFv3
Dear all, I am trying to configure a network of ER (Pro and Lite) to get access thru GRE tunnel some OSPFv3 to redistribute : Default routeLoopback interfacesLocal lan network and static IPv6...
View ArticleEdgePoint R6 or R8 ?
Was wondering if i should go for a R6 or R8 for a 250 mbit connection main router for small community. I dont need but three ports and only 24v devices. But i was wondering more about if its better to...
View ArticleERX as PPPoE Client with /30
Hi Folks, This may seem an obvious question but I'm new to EdgeOS despite being a long time user of UBNTs other products & a Cisco/Fortinet head (sorry for swearing haha). Planning a config &...
View ArticleAccess DCHP Router Address from each VLAN except Guest
Hello, I have a ERX and I was trying to block the VLAN 14 (Guest) from accessing the router address. I used the set service gui to have a different address outside the VLAN so guest users could not...
View ArticleClik here to view.
Help To Connect to Networks
Hello,I hope someone can help me please.I have 2 ER-X-SFP running 2 NetworksThe ER-X-SFP#1 is connected to the Internet and some PCs are connected to that Network (192.10.10.0/24)It is configured using...
View ArticleClik here to view.
Routing ignored
I have been chasing this problem for several weeks and searching the forums. I have an EdgeMAX Edgerouter X v1.8.5. Problem is that the routing table is being completely ignored. I had set up the...
View ArticleIPSec Site to Site VPN - Aggressive Mode
I'm setting up a Site-to-Site VPN which currently is configure for a PSK, and needs to be aggressive mode.I've enabled i_dont_care_about_security_and_use_aggressive_mode_psk = yesand manually...
View ArticleHelp with Load Balancing2 Wizard
I've been trying to get the load-balancing wizard to work with a pair of ER-POE5 routers here at work. I'm pretty sure I'm entering the correct IPs in the fields for the wizards on both units and the...
View ArticleEdgeRouter lite upgraded from 1.8.0 to 1.8.5 -- eth2 has vanished!
The subject pretty much says it all. There is a cable plugged in to the eth2 socket and it's lit. The status display for eth2 on the dashboad is blank. Eth2 is not showing up on the list of interfaces...
View ArticleER-X-SFP - setting the SFP port speed
I would like to use the SFP port on the ER-X-SFP to connect to an Edge Switch 24 Lite. The problem seems to be that I need to set or force the port speed explicitly to 1000mbps on both sides. This...
View ArticleSupernetting on EdgeRouter Pro
Hello, I just took over a project here in which the original admin installed an EdgeRouterPro8. I need to change the network setup so that it has a 255.255.248.0 netmask to accomodate over 400...
View Articlenewby to ERL, create a tunnel with split tunnel
I have a Office here in WA and one in BC, Canada, I have Comcast here and Telus in Canada, have a static IP at both offices offered by the respective modems in each office in bridge mode. I bought two...
View Articleedgerouter poe only console port lbinking
Good Evening i have a problem with my edgerouter PoE today it apeared with the console port right light blinking and all the other ports on the router off i have no conection to any port including the...
View ArticleHaving issues w/ IPSec VPN setup
I'm having issues with my vpn setup and could use a bit of help. My setup is almost there, but is acting.. weird.. I'm attempting to connect my Windows 10 laptop to the vpn for testing (the laptop is...
View ArticleHow to allow ALL VLANs to print to one device?
Hey everybody, I've been reading through the posts on allowing multiple VLANs/subnets to print to one specific IP, and am trying to get a consensus on the best way to do so. My setup: Corp 1:...
View ArticleVoIP QoS
I have tried the qos guide here: https://help.ubnt.com/hc/en-us/articles/205198380-EdgeMAX-Quality-of-Service-for-Voice-Over-IP-QoS-for-VoIP- The customer having issues is using cisco ata devices on...
View ArticleERPoe-5 Stopped working
Just a home application and I'm not an IT guy. Have had the above router running without issue (not even needing to reboot) for almost 8 months now supplying internet access to our house (installed...
View ArticleHELP: Site-to-Site VPN Dropping Connection
I have two EdgeRouters connected via Site-to-Site VPN. The connection is great but it drops 1-2 times an hour and the downtime usually lasts 1-5 minutes. This doesn’t sound like a big deal but it is...
View Articleer6 lan speed problem
have 2 er6 on one have one airfiber which all time link is 1gb/s,on rocket ac lite after 2-3 days link go from 1gb/s to 100 mbit/s .I checked on rocket flow control and unchecked,always the same,cable...
View Article