Need help removing bridge
Can someone help me remove the bridge from my configuration? I tried doing:delete interfaces ethernet eth1 bridge-group But once I did that I lost my network connection and had to reboot it. I'm not...
View ArticleClik here to view.
Problem with L2TP/IPSec and DNS
Hi all, Im the proud owner of an ERL and I've configured it succesfully. I've a Synology NAS. Who is capable of hosting a VPN Server. The configured protocol is L2TP/IPSec. And I was thinking... My ERL...
View ArticleClik here to view.
Possibility to stack 2 EdgeRouter Pro 8?
Hi all, As i couldn't really find any information via Google, hope you guys here could help me with my question. I would like to know if its possible to stack 2 EdgeRouter Pro 8? I asked this because...
View ArticlePer IP Bandwidth Limit
SonicWall has a feature that allows you to set a hard limit per IP. https://support.software.dell.com/kb/sw12385 Can you do something like this on a EdgeRouter Lite? I want to say that any IP can use...
View ArticleBasic config with OpenVPN setup
Hello Chaps, I have been trying to get OpenVPN setup on my ERL for awhile and I am not making any progress. Would someone be willing to post a config or send one to me that has it already setup? I am...
View ArticleFirewall Policy source Mac address
I am trying to setup the firewall rules on my ERLite so I can RDP onto my machine at home. I have setup the DNAT and a ruleset on my WAN_IN firewall policy that currently only allows traffic from my...
View ArticleEdge Router IPSEC VPN to Watchguard
I am new to EdgeMax Edge Router. I have been trying to test a new Edge Router Pro to a Watchguard XTM330. I have read just about every article and still I am not able to get it working. I have attached...
View Articlel2tp Edgemax 1.9 firmware is not working
Good day! I have a problem with l2tp in Edgemax after upgrading the firmware to 1.9 version.Before upgrading it works fine.I used this man...
View ArticleEdgerouter POE and Unifi AP AC light
Hi Im new to Ubnt, im having trouble setting ut my access point to the Edgerouter POE, it will only flash blue and not show up on my controller.If i plug it inn to my service provider router it starts...
View ArticleStatic Host Mappings Stopped Working after Reboot
Hi all, Had a power loss here at home tonight. Everything rebooted just fine, but now none of my static hosts seem to be working. I had my backup server mapped to "server.example.com" and the...
View ArticleStep by Step Parental control guide
Hi. I have a teenager who is online too much and an Edgerouter Lite running 1.7. I would like to be able to limit internet access for specific mac addresses to certain hours of the day, like 19.00 to...
View Articlesite-to-site ipsec and L2TP remote-access at the same time.
I got two EdgeRouter Lite with firmware v1.9.0 and I got an site-to-site ipsec tunnnel that works stable between them.. Now the need for l2tp remote-access ha come on one of the sites but when i add...
View ArticleRoute to remote subnet over IPSec tunnel - Cant get traffic to pass?
So, i have three routers:RTR-A:Lan subnet of 172.16.254.11/24 on Eth0Wan subnet of 11.11.11.11/29IPSec tunnel to RTR C"Hairpin NAT" enabled (By default)"Automatically open firewall and exclude from...
View ArticleEdgeRouter 1.9 DHCP different gateway for a bunch of devices
Hello,I use EdgeRouter Pro 8 for a small network to serve DHCP for all of devices. I use static mappings for majority of them. For a couple of handheld terminals I would like to use different that the...
View ArticleDPI Firewall - No Entries for Top-Sites-Adult but fall within Streaming-Media...
HI Forum, I'm trying to use the DPI Firewall feaure on an ER-X, specifically to block access to a certain Adult category. However on examination this category seems to be empty EdgeRtrX:~$...
View ArticleClik here to view.
ER-X Masquerade issue with pure switching configured
Hello, fellow Ubiquiti guys.This is the first time I post into this forum, so please don't be mad if anything is wrong.I come from MIkrotik world, trying to get accustomed to UBNT way of doing things....
View ArticleProblem Send Mail Office365 and Exchange
Good Morning, 99% that the problem may be in edgerouter.If you remove edgerouter from the network, everything works a better a much more faster.IMAP and POP it´s OK.Looking at my dashboard I noticed a...
View ArticleHow to log current transfer rate and total from WAN interface?
I would like to be able to log the current transfer rate & total amount values that are seen on the EdgeMax dashboard screen. I could script the login process and pull the data from via the...
View ArticleClik here to view.
Configuration and Portforward/DNAT
Hello, I have a configuration issue that I could use some assistance with. The first question is setup. We have an external ISP that comes into a switch which I have connected directly to three ER-X...
View ArticleVPN L2tp connection stops working after a connection IP change
Here is the issue I'm having with my ERPoe-5 on EdgeOS 1.9 I'm sitting on a connection with a dynamic IP so basically the session gets reset randomly every 24 to 72 hours. I've configured my VPN to...
View Article