Edgerouter and Cisco SPA112
Anyone using this combination? I have 4 of these and want to exchange the router for a Edgerouter. I tried searching the forums and all I find is people having problems with it and can't see that...
View ArticleFound another case where dashboard stops works
I am not sure if this is the forum for this post, if there is a better one and admin need, please feel free to move it. I know there are some reported problems with the dashboard, about stops working...
View Article2 Wans 2 Lans Isolated
Hi guys thanks in advance for your help. I'm trying to do the following:eth0 eth0.3 Wan A (DHCP ISP) eth0.23 Wan B (DHCP ISP)eth1 Lan A 192.168.1.xeth2 Lan B 192.168.2.x I need each Lan working with...
View ArticleClik here to view.
ER-X two switches
Hi, I is there way how to set up ER-X-SFP with two switches?I need eth0-4 as switch0 and eth4 and eth5 as switch1. Preferably CLI way.Runnig version 1.7
View ArticleEdgerouter Lite DHCP Not Assigning IPs
I'm relatively new to EdgeMAX and Ubiquity products in general. I picked up an EdgeRouter Lite a few months ago and got it set up and had not problems until yesterday. Suddenly the dhcp service is...
View ArticleWhere to copy openvpn files?
Hi, I'm currently running a VPN sever on my Synology NAS and it works relatively well. I use it to connect home from outside with various clients (laptops, Android phones, etc.) - no site-to-site...
View ArticleEge Router Lite Dropping Connection to DSL Modem in Bridge Mode
Hi all!The unit runs 100% on eth0 for about 12-20 hrs then it drops dead.I am in basic configuration mode with dhcp enabled connected to a DSL in Bridged Mode.Once it drops from internet the dhcp also...
View ArticleFirewall PBX issue
Hi Everyone, thanks in advance for any help you can provide. I just installed a new edgerouter x and edgeswitch 24 at a clients site. I have gotten everything working with the exception of one thing....
View Article3 Dead EdgeRouter Lite
Let me start by saying I love UBNT products. I have about 30 EdgeRouter X's at different small businesses and have never had any issues with them. On the other hand I have purchased about 5 Edge...
View ArticleLoad Balancing Issue
I currently have a load balancing setup where I have 2 VLANs and 2 WANs. VLAN 20 connects on WAN 2 (eth2) by default, fails over to WAN 1. WAN 2 is a cellular internet used for VOIP because the DSL is...
View Articleeth0 down?
About every day now my WAN port, eth0, decides to stop recieving and transmiting and then disconnects on my edgeMax pro router. After about 5 minutes it comes back online. Attached is a screen shot. Is...
View ArticleClik here to view.
EdgeRouter Lite Boot Problem.
Hello Ubiquiti Support, I am having an issue with my newly bought EdgeRouter Lite. Got it to a point where it was working and then rebooted and it didn't come back up. I loaded up the console and got...
View ArticleISP WAN Block IPs and LAN IPs Setup in EdgeRouter
Not sure how to set this up to make it work in my new edgerouter. Maybe someone could help guilde me and help explain this a bit more. LAN IP BLOCK:xxx.xxx.xxx.16/28Subnet...
View ArticleDHCP Relay Not working
Can anyone point out if I'm doing something wrong here? I have an edgerouter 5 port connected to an edgerouter pro on port eth1 and connecting clients to the switch0 interface. Edgeroute Port 5:...
View ArticleCan I USE EthetIP over IPSec?
Hi, I'm using ERX(ver1.9.1a2) and I would like to know ERX support etheripprotocols. "etherip protocols" is not listed Ubiquiti Networks Products support list.So, It may not support --i guess. But I...
View ArticleEdgerouter X as switch, but how to access it?
Hello guysI've configured my new edge router X as a switch via build-in wizard. but I would like to enable PoE out on port eth4 so that I can connect another PoE device there. however once I finish the...
View ArticlePPTP with zonebased firewall.
I have made a setup with ERLite, Unifi Switch 24 and UAP LR for a multi-tenant situation. VLANs 50 and 100 for the two tennants. Because I will build a quit large multi-tenant network in the near...
View ArticleCan an ERL run dual VPNs, i.e. privacy and remote access?
I've been trying to wrap my head around this and can't, so I thought I'd ask here. A friend (really!) is interested in running a VPN for privacy from his router to protect all the devices in his home-...
View ArticleNeed some tips on setting up the ERP with UAP-AC-PRO, along with other...
I've been using Asus routers, and I've gone through several over the years. I used the RT-AC68U, and that was great for range and throughput. I upgraded (or so I thought) to the RT-AC3100, but my...
View ArticlemDNS forwarding so that iPhone can communicate with iTunes on a PC
Hello,I know this has been discussed before, but I'm not sure I've seen a confirmed solution anywhere.I'll make this simple: I'm trying to get my iPhones/iTunes sync working when the iPhone is remotely...
View Article