I'm relatively new to EdgeMAX and Ubiquity products in general. I picked up an EdgeRouter Lite a few months ago and got it set up and had not problems until yesterday. Suddenly the dhcp service is not assigning IP addresses (static or dynamic) on one of the ports and on the other port, it's not showing any leases although IP addresses are assigned. I've attached my config.boot from the setting backup I downloaded from the router. I masked some of the values with XXXXXX to protect some semi confidential info, but otherwise it's exactly as it is set up.
I'll explain the network setup a little for background.
eth0 is connected to a wifi AP and that's it. That's the one that is working, though when I look at the DHCP settings screen it shows no leases.
eth1 is connected to a TPLink TL-SG108E switch which has several devices attached to it including a second wifi AP and an unmanaged switch. All devices that have their own static IP assigned (meaning the device setup has the static IP set) are working fine. If I connect a new device to either the switch or the wifi AP, it never gets an IP address assigned. If I connect a device that is set up in the static-mapping with it's MAC and IP, but the device itself doesn't have a static IP address set, the device also never gets an IP assigned.
eth2 is the WAN port connected to a cable modem which dynamically assigns the IP address assigned by the ISP to the router.
It was all working as expected until yesterday. I made no changes to the setup. I attached a new Steam Link device that I bought over black friday and it never got assigned an IP. I had to manually set the IP on the device eventhough I tried setting up a static mapping on the router. I also recently got a new Android phone. It connected just fine on Monday and Tuesday, but yesterday I wiped the device and when I tried to connect it to the AP on the eth1, it just keeps saying Obtaining IP and then gives up, disconnects and tries to reconnect. Also, tried connecting my work laptop via both the wifi AP and a port on the switch and it could not connect. It definitely worked via wifi the previous evening because I work from home every evening. If I connect it to the AP on the eth0 it works fine, but again, no lease shows up as I would expect.
The list is blank when I run:
show dhcp leases
The only errors/warnings I see in the logs are related to martians which I assume is due to devices trying to connect but not getting appropriate IP addresses.
Any help would be greatly appreciated! Thanks in advance.
