Filter traffic over IPSEC
Hi All,I hope I'm not missing something completely obvious. I've configured an IPSEC tunnel between an EdgeRouter Lite v1.9.0 and a pfSense firewall. The VPN is functioning fine, and traffic is...
View ArticlePort eth 2, 3 and 4 disconnected after PoE sets to on in port eth 2
Egderouter Poe 5When I set Poe to on to port eth 2 in the router this three ports suddenly got disconnected.And the Unifi controller can not find any device. One UAP AC Pro is connected to port eth...
View ArticleRouter: how important is it?
I guess this is more of general networking question, if that is ok? How important is a router when it come to the speed of moving files around? We currently use a bunch of consumer switches and small...
View ArticleEdgerouter PRO Multihoming with 2 ISPs BGP
Hello guys I am new to networking world. I have a project where I need to run BGP and multihome with 2 ISPs. I have got 2 ISPs, HE and AMX-IE. Both are providing 1gbps each. I have my own /21 and AS#....
View Article1.9 breaks config on ER-X
Hello, I was using an ER-X with EgeOS 1.8 as an OpenVPN client for a host on my network (so I wouldn't have to install & configure any OpenVPN client software on the host). The host would send all...
View ArticleUsers reporting they are experiencing session timeouts
The topology is a ER8-Pro with 5 ES-48 switches behind it. The users are using an old app that connects to the server using telnet as the background transport protocol and they often leave the...
View ArticleER-X Speedtest is super fast but websites are slow to load
Any ideas? Not sure where to start...running latest version 1.9.0. Configuration below.firewall { all-ping enable broadcast-ping disable ipv6-receive-redirects disable ipv6-src-route disable...
View ArticleEdgeRouter Lite - 2 LAN routing and port forwarding
Hi!On my edge router lite with v 1.9.0 I have 1 wan interface (Eth 0) and two lan interfaces:Eth1 10.52.72.254/23 "intranet"Eth2 172.16.51.126/25 "guests"Both are connected to managed switch with...
View ArticleERL to Cisco ASA Site-to-Site VPN Guide
Hello all - I was setting this up recently and had some trouble finding all of the required information in one post. Most of waht i could find were posts on why it wasnt working but not really one to...
View ArticleProblems with routing inside 2nd subnet
Hello everyone, I'm having trouble with using public ip adresses of my 2nd subnet. When configuring a public ip in my network i can not reach the public ip from outside the network. My setup is as...
View ArticleEdge Router ER-X Vpn site to site
Hi, I need to connect two sites that are accessed with an internet service with radio links ubnt managed by the provider. in practice the internet access to both sites can be used alternatively, as the...
View ArticleNeighbor Solicitation not working for LAN devices
My ERL v1.9.0 is not responding on the link local interface.The router is sending neighbor discovery messages (as seen in the TCPDUMP bellow) but never receive an answer ??? So I suspect that for some...
View ArticleERL and 2fa solutions for VPN access
So here is my situtation. We sell and deploy ERL's to our customers. Currently, we are setting up the PPTP VPN on the ERL with RADIUS auth for remote access. We use the Windows VPN client to connect...
View ArticleOdd RST packet/conntrack behavior
I've noticed that with use of an INVALID packet drop on WAN inbound (IPv4 and IPv6), RST packets in particular appear to be 'falling out' of the conntrack on a pretty regular basis. In fact, having...
View ArticleClik here to view.
Question on edgerouter for homelab
Pretty straightforward question.I need to upgrade my current router to something much better (faster, secure, flexible) including VPN capabilities. I work from home 50% of the time and then travel the...
View ArticleEdgeRouter X ADSl & LTE Dual WAN Setup and Failover Help
Good Day,I'm investigating the possiblility of hooking two WAN connections to a EdgeRouter X. One being a 20mb/1mb ADSL and a LTE-A connection (Fixed). My aim here it to use the ADSL connection for...
View ArticlePort Forwarding and Plex/VPN
I cannot for the life of me get port forwarding to work and so cannot get Plex to work nor VPN. Can anyone help show interfaces Codes: S - State, L - Link, u - Up, D - Down, A - Admin Down Interface IP...
View ArticleMacBook will not see printers on different VLAN even with mdns settings...
Setting up an ER-X at a school. Have a Staff, Student and Printer VLANs. Have others as well, but those are the ones in question. Windows machines on the Staff VLAN can print to the Ricoh printers on...
View ArticleRemote Access
Hi, I would like to be able to login into my edgrouter from another location, how do i set that?
View Article