Hello,
I was using an ER-X with EgeOS 1.8 as an OpenVPN client for a host on my network (so I wouldn't have to install & configure any OpenVPN client software on the host). The host would send all traffic to the ER-X and the ER-x was setup to send all that traffic over whichever OpenVPN tunnel was up based on the load-balancing config. After upgrading to EdgeOS 1.9 this host loses all Internet access. If I remove the firewalls from the interface I regain Internet access but not over the OpenVPN tunnels even though the tunnels are up. I can probably figure out what needs to be changed on the firewalls by looking at the log if I could just get the ER-X to pass the hosts traffic over the VPN tunnels. I've attached the config that works with EdgeOS 1.8. openvpn vtun11-12, 21-22 are the tunnels the hosts traffic should be going over. The other tunnels are for remote access to my LAN which I've yet to test since upgrading to 1.9.
Thanks,
->g.