EdgeMax - ER-X - Throughput reports for dashboard?!
As many do I am sure I have multiple products, I have Wifi APs and an Edge Router. I was surprised when the UniFi controller was upgraded to have the ability to manage your gateway, yet it can not get...
View ArticleSlow transfer speed through interfaces
Hello all, New to the Ubiquiti family. This is for my home network. This might be a limitation\understanding or misconfiguration I have made. However, when I try a file transfer of a 4 gig file from...
View ArticleHow quick can I expect ERL in default 2WAN+1LAN load balance configuration be?
Two 250 megabit connections, one static, one dynamic. Complete factory default with reset button sequence. Ran through the load balancing wizard, selected default firewall for both WAN. Fastest I've...
View ArticleClik here to view.
Using OpenDNS over VLAN setup
Due to the fact I want to use my Edgerouter as gateway instead of the router my ISP provides I had to setup my netwerk the following way: On my previous connection I setup OpenDNS in the Edgerouter...
View ArticleUnable to connect to all Internet sites
After configuring the Edgerouter Pro (firmware 1.9) not all website are reachable. Here is the config: Local Bridge (br0) 192.168.35.1 (eth1, 6 and 7)DHCP 192.168.35.100-199 DNS 8.8.8.8 and...
View ArticleIs their a way to mass set a qos simple queue in erl
I need to setup a qos simple queue rule as follows for a block of 150 IPs is their an easy way of doing this without having to do an entry for every IP source ip (IP of Device) / Dest IP (ANY) /...
View ArticleUpgrade to 1.9.0 failed
Was trying to upgrade to 1.9.0 from 1.8.5 and: admin@ubnt:~$ add system image https://dl.ubnt.com/firmwares/edgemax/v1.9.0/ER-e50.v1.9.0.4901118.tar Trying to get upgrade file from...
View ArticleEdgerouter Lite QOS speed issues
Hi, I've an edge router lite and a 50/4 connection. I've the smart queue enable and I'm seeing that I can't pass the 30mbit down, when I disable the queue, I can download full 50mbits, I understand QOS...
View ArticleOffloading and random reboots
Kind of an off the wall issue, I haven't tried it in a while now. If I enable offloading I get random reboots. What more infomation would we need to figure this out?
View Articlenetflow and sequence errors
i am running an EdgeRouter Prov1.9.0 eth0 == comcast cable modemeth1 == edgemax switch i have nfcapd running on an Ubuntu VM on Hyper-V, ip address 192.168.1.8 my config looks like this: ubnt@ubnt#...
View ArticleEnable and disable internet access to devices
Hey all, I am tired of plugging/unplugging my kids network cables from computers, and taking their phones to avoid them using internet... sure there are probably things I can do like just sell...
View ArticleClik here to view.
ER-X platform thank you
Hello all, I just wanted to say thank you to the Ubiquiti team for the ER-X. Great job! Back when I purchased the first one for a client it was only because it was less expensive than and ERL and...
View ArticleOpenVPN Configuration
After finally dealing with a dreaded certificate error, I'm back with another. I'm attempting to configure OpenVPN to support dual-stack ipv4 and ipv6. I tried a few commands such as enabling...
View Articleany issues with my config? (RE: firewall mostly)
firewall { all-ping enable broadcast-ping disable group { port-group snmp { description "block outgoing snmp" port 161-162 } } ipv6-receive-redirects disable ipv6-src-route disable ip-src-route disable...
View Articleip sec client to server vpn
I have a cloud server that has a static wan ip (no router) I need to connect a edgerouter lite with a vpn. I cant seem to get itto work . Any help would be appreciated.
View ArticleConfiguration failure after upgrade 1.8.0 to 1.9.0 in traffic-policy (dscp...
After upgrading, my boot produced a "failed" in red message. Manually loading the config and comparing showed a failure in a traffic-policy. Further narrowing it down showed the offending line to be...
View Articleport 53 visible from WAN side???
config included. Is this how it's supposed to be? What am I missing?firewall { all-ping enable broadcast-ping disable group { port-group snmp { description "block outgoing snmp" port 161-162 } }...
View ArticleEdge poe 5
I dont usually work with edge equipment but my recent falling out with the unifi gateway made me want to try it. I connected the wan to eth1 it got an ip. i connected one lan to eth2 and one to eth4...
View Articlebgp crash on 1.8.5
hi, i have 1.8.5 on a edge pro and once every two weeks or so, I get bgp crush... and it works after a reboot.I collected some core-bgpd-xxx and some core-nsm-xxx files, to whom may I send them for...
View Article2 WLAN over bridge with Failover Help Please
Hello Guys, So I will try give as much detail as possible because I am bit desperate for help, I will start by saying I am still getting to grips with Ubiquiti and the CLI. I have attempted to follow...
View Article