Im new to the Edge router and I configure the router through the WEB-GUI.
The situation is as follows:
There is a fiber switch from the ISP that delivers 3 WAN connections. I would like these to be handeld by a single router and route these to separated networks.
What I have done so far is set-up the PPPoE sessions and made PBR rules for each PPPoE interface to LAN interface.
This seems to be working (tested it after setting it up) but at some point, for some reason all the three LAN seem to favor using a single WAN (the second in the conf = yy.yy.yy.yy;
As soon i disconnect this line after a little while the LAN1 goes over the WAN1.
Hope you guys can help me out on this one.