DPI "Other" Category
I was looking at my categorised traffic, and a lot of the traffic is categorised as "web - other" for lots of devices. I'm planning on analysing the traffic this weekend with Wireshark, but how can I...
View ArticleGetting VLAN's to communicate
Hello everybody,Forgive me if this is something that has beed answered, I have searched for a few days and cannot figure this out.I decided to change my network a couple months ago and am not 100%...
View ArticleERLite-3 + Dual WAN not balanced to LAN with 1 VLAN
I have been trying to configure an EdgeRouter Lite-3 to use two WAN connections to route a LAN to one of the WAN connections and a VLAN for a guest wireless on a UniFi system to the other WAN...
View ArticleSmart-Queue QoS
I have a question that I could not find a direct answer to. I enabled Smart-Queue QoS and set it as 1000Mbps upload and download, what my service provider allocated me. Testing upload and download...
View ArticleBlocking traffic from IPSEC Tunnels
Several EdgeRouters running IPSEC site-to-site tunnels between them. Just routing between the subnets by specifiying the local and remote subnets in the configset vpn ipsec site-to-site peer...
View Articlebeen asked before
Guys I apologize in advance for asking a repeated question but after reading 2 dozen messages about the same thing I am totally lost. running an ER-x using only eth0(internet) and eth1(lan) I want to...
View ArticleER-X sfp not responding after power outage
Hi Guys,I cannot enter or even ping my ER-X SFP after a power outagefirst thing i'd wanted to do is ti reset the device seems working the eth4 led is blinking, but impossible to join the defautl IP...
View ArticleEdgePoint R6 is not visible from our network
We are an ISP in Northern Virginia and we are currently using Ubiquiti radios with Mikrotik 750s at our towers. In our new deployments, we are using the EdgePoint R6 instead of the 750. We are having a...
View Articlezone firewall slow?
is zone firewall slower than normal? is there another way to mimic zone firewall which is faster? all i want is traffic from LAN1 to LAN2 = drop by default, and whitelist some. is 1000 lines with zone...
View ArticleEdgerouter POE high CPU usage
I'm running v1.9 on an edgerouter but there is a problem with its CPU getting pinned at 100% when I download a constant 80-90 megabits. Everything lags, even logging into putty will take an extremely...
View Article1.9.0 Basic Queue Application List Blank
So my EdgeRouter Lite died (more or less) and I bought a new EdgeRouter X (didn't need the extra power). So I backed up the config and restored it to the X without any issue. I had to run 'set...
View Articleradvd dies when pppoe drops
With the EdgeRouter deployed using PPPoE+DHCPv6 on WAN, it seems if PPPoE drops due to a loss of layer 1 or layer 2 radvd stops working. Scenario:ISP performs network maintenance and restarts a switch...
View ArticleFailover/Loadbalance VOIP
There is a lot of posts around the forum about this but none of them is quite what i am looking for or i havent been able to find it. i have an Edgerouter Pro with 2 different WAN connections load...
View ArticleRestart or restore traffic-analysis service defaults
I have a firewall rule that blocks custom-category 'youtube'i disabled DPI because at the beggining started to work well. but from one moment to another he blocked also googleFirst i disabled the...
View ArticleUnable to ping server by host name on different subnet
EdgeRouter 5-port PoE v1.8.5 I have two internal interfaces setup, eth1 for LAN (192.168.0.1) and eth2 for WLAN (192.168.1.1). I can ping devices on LAN using their hostname if I ping from another...
View ArticleEdge Router X - Since 1.9.0 pppoe rx/tx counters not working?
It seems that since 1.9.0 the RX and TX counters for the pppoe conection on the dashboard are not working correctly. I believe that before 1.9.0 the pppoe interface counters were working. Looking at...
View ArticleDisable load-balance for OpenVPN traffic originating from EdgeRouter Lite
I've enabled load-balancing on two WAN links on my EdgeRouter Lite. This EdgeRouter also sets up an OpenVPN link with an OpenVPN server in a datacenter. Since enabling the load-balancing, it tries to...
View ArticleClik here to view.
WAN+2LAN to Load Balancing
Next week I'm getting a second internet connection which I want to use as a failover connection. So I'm looking to change from WAN+2LAN to Load Balancing. I have already looked into the wizard and...
View ArticleEdgeRouter Lite throughput performance
Hi community I´m in the process of upgrading my Internet connection from 50/50Mbit to 1000/1000Mbit. I would like to replace my 8 year old SOHO router with something that can handle the new connection....
View Article