ER-X and Airfiber 5X Power
hiI havean ERXand aAirfiber5XI canuse aUbntPOEadapterat24V and24Wtopower theAirfiberI think aboutERXcan handle itonethportin the long runso it is not damaged at the other end ofthe link, I havean ER...
View Articlehost name not found for ubnt.pool.ntp.org
Hello, I'm getting these errors. I upgraded firmware to 1.8, and I have three name servers, all valid, set up on the device. I rebooted it, same problem. This occurred 5/21/2016 at 2:55pm. Dec 31...
View Articleedgerouter lite unresponsive after power outage
We had a power outage the other night which caused my edgerouter lite and unifi AP to stop working. When i follow the instructions in the qsg to reset, only the bootup method makes the right led blink...
View ArticlePPPoE server firewalling clients.
When using the PPPoE server, how is it possible to apply firewall rules to PPPoE clients? I'm trying to acheive two things really. 1st I want to isolate PPPoE clients from other LAN segments, from...
View ArticleTraffic analysis for IPv6
Is IPv6 DPI not supported by hardware or the code is just not there yet?
View ArticleClik here to view.
Ipsec site-to-site behind livebox using GUI
Hi, I'm trying to setup a site-to-site VPN using GUI interface.I have the following configuration Edge Router X ====> ISP Livebox with WAN access ===== Internet ===== WAN access using 4G Modem...
View ArticleCan't run udp ovpn server and udp client at the same time?
Hi, I am running a ovpn server on my POE5, udp, port 1194.I have been also running a ovpn client on this router, tcp, port 80.No I had to reconfigure the client to use udp, port 53 but found that I...
View ArticleGRE Tunnel Weirdness
Have a EdgeMax Pro with a GRE Tunnel setuptunnel tun0 {address xxx.xxx.xxx.170/29encapsulation grelocal-ip xxx.xxx.240.194mtu 1476multicast enableremote-ip xxx.xxx.120.38ttl 255} Other end is a Juniper...
View ArticleQOS to prioritize one SSID over another
Hi, I'm in the process of setting up a small wifi network for my local camp. I have the following: Unifi AP-AC-LRUnifi AP-Outdoor+Unifi Cloud KeyEdgerouter ERLite-3TP-Link 8 port switch I have 2...
View ArticleConfiguration Help
I have a attached an example diagram of my setup. I think I had it working at one point but now I cannot seem to get back to it. Normally the Home LAN would route 0.0.0.0/0 through ETH0 but also be...
View ArticleUSB Modem support
Hi! Some people requested support for USB modems. In some scenarios we would like to use USB GPRS/HSPA modem for emergency access for routers. Is there any reason that USB modem support is still absent...
View ArticleEdgeMAX router x -loadbalance
hii , I want to config load balance in edge router x and 1 port for lan 192.168.1.1/24how it the best config settings?My speed is 100/2mb *2=200/4mb1.The edge x handle with the speed ? 2.if i make...
View ArticleClik here to view.
Basic CLI Setup, set Port-forward, Vayatta Documentation
I spent alot of time going through ubnt gui for my Edge router and Unifi controller for my UAP and just wasnt having it so i decided to look for the CLI documentation which still is difficult to...
View ArticleIP aliasing
Hello,I would like to know if it is possible to give to one interface several IP address associated with as many different subnets (and not 2 IP address in the same subnet for example !) ? And so as...
View ArticleInterface fail-over
Hello,I would like to know if it is possible to implement a fail-over between 2 interfaces. I mean, having an active main interface and a passive backup interface, on different subnets. I don't speak...
View ArticleClik here to view.
PPTP VPN Passthrough
Hi guys, I have a trouble connecting to VPN Server in the next scenario:I have the central office server with a vpn server configurated with IP 62.14.249.109In my control side I have the EdgeRouter...
View ArticleHow to block OTHER DHCP servers?
I am setting up a new WiFi network and I am using the ER-5poe. I have:eth0 as the WAN with a public IPeth1 unused but will eventually use it as a way in from the customer's subnet. eth2,3,4 configured...
View ArticleBasic SOHO config help
Hello,I had earlier posted this query to the Ubiquiti Support, but am still awaiting a reply to this.We've heard great things about the ERLite-3 product & would ideally like to use it, but it...
View ArticleRandom reboots
EdgeRouter Prov1.8.0 randomly and frequently reboots itself. Any thoughts on what I should be looking for to solve this problem?
View ArticleBUG - SquidGuard Redirects No Longer Working in 1.8
Greetings, After upgrading from 1.7 to 1.8, my SquidGuard redirects are no longer working properly, but my users get redirected to a page that says a URL error occurred and "Access denied." This is...
View Article