Quantcast
Browsing all 20028 articles
Browse latest View live

EdgeRouter X SFP to XFP 10g 850nm LC conversion

I have recently inherited a start up network where the tech before me ordered a 10g fiber connection for internet service. The circuit was delivered as 10g XFP provisioned for 1g. The module in the...

View Article


Route traffic from/to a local IP address through a specific WAN in a load...

Hi, I have an EdgeRouter X at home with 3 WANs configured with load balancing via the Load Balancing Wizard and 1 LAN. There is a problem however with my IPTV set-top-box, which needs to reach the IPTV...

View Article


EdgeRouter X dual WAN and 1 LAN with load balancing

Hi, I'm trying to convert the configuration of my router (which actually has 1 WAN - with a LTE router - and 2 LANs) to dual WAN (with the existing LTE router + another one with another carrier) and 1...

View Article

ER-X disconnects from WAN when computer turned on

I have an ER-X connected to a ToughSwitch and 2 UniFi APs in my home office.I've been having an issue where the entire network goes down when I power up my desktop computer, which is connected to eth1...

View Article

Downgrading from 1.9 to 1.85 to fix Dual WAN failover and VPN

Hello, I have followed the suggestion by  and run a script, that did make the VPN work with Dual WAN failover...

View Article


MPLS & BGP VPLS

Before there was a shortcoming in doing BGP VPLS in that you had to do full-mesh BGP.  Has this changed?  ie. does edgeos do BGP route reflect?  If not, can it peer with a different router that can do...

View Article

Pin HE IPv6 tunnel to a single interface with load-balancing

I have been trying to figure this out for a while but still am failing to get my head around it. I have my ER-POE setup with load-balancing between two pppoe WAN connections (eth0 and eth1). pppoe1...

View Article

1.9 OSPF-4: Detected router with duplicate router ID

OSPF[920]: OSPF-4: Detected router with duplicate router ID<this-routers-id> in area 0.0.0.0I've noticed this very intermittently in the logs of some of my routers, usually around the same time...

View Article


1.9 snmpd smux errors in log

snmpd[5664]: refused smux peer: oid SNMPv2-SMI::enterprises.3317.1.2.5, descr zebos-1.2.0 OAM[4686]: OAM-6: SMUX_CLOSE with reason: 5Is being spammed every 10 seconds or so on one of my routers. Any...

View Article


Image may be NSFW.
Clik here to view.

help with pppoe erlite-3

Hey guys, looking for your help! Im no EdgeOS/Vyatta expert so im sorry if im overlooking something dumb.  I have an erlite3. Used the load balancing wizard for setting up eth0/dhcp and eth1/pppoe(fail...

View Article

Temporary load-balance fix (VPN and L2TP) to add connected routes

There are way too many posts about issues with VPN and L2TP with load-balance config on 1.9.0 firmware.The issue is being tracked by UBNT (see beta forum # 6 HERE) and hopefully we'll see permanent fix...

View Article

LAN can see IP's on WAN side

Hi, I'm new to Edgemax Routers and need a little help. I'm trying to setup a Edge Router lite inside a network to seperate an office with a different subnet.I've configured Eth0 as static WAN with...

View Article

Subnet Isolation with zone policy

Hello, I am running into a odd problem I am not sure how to solve when isolating subnets using zone policies on my ER-X. I have created 3 vlans, a main network, a management network and a guest...

View Article


Online Matchmaking Issues with EdgeRouter X

Hey all, I am having issues with my Edgerouter X and online matchmaking for Battlefield 1. For some reason, whenever my computer is connected to the router, I cannot connect to any game whatsoever. I...

View Article

Forward WAN to VLAN tagged interface

Hi I have a case where I'd like to forward the WAN network through my ERL to a specific VLAN tagged port on my router.I was wondering if it's possible to do so? And how to do so

View Article


Edgerouter PRO - Disaster recovery

When I read through the forums I see a lot of members actually using the disaster recovery for the Edgerouter Lite.Which makes sense as the usb flash storage could easily get corrupted and needs to be...

View Article

New EdgeRouter Pro Setup Issue, no Internet connection.

Hi, I just received my EdgeRouter Pro today and I have a simple 192.168.1.X Verizon Quantum Router. I setup a DMZ IP on the Verizon router to 192.168.1.100 then connect from Verizon into eth 1 and my...

View Article


Edge Router Lite - packet loss

I recently purchased an ERL and configured it to have eth0 as WAN interface and eth1 and eth2 as br0 doing DHCP and NAT.  This worked fine at home (Belgium) as test setup: clients - ELR - Fritzbox...

View Article

OSPF issue using vti

I've setup a vti to use ospf over an ipsec tunnel between two routers. If I ping the other router it goes straight to it but if I ping a device on the other network it goes via the VTI adding a hop....

View Article

ERLite-3 Rack kit

I'm desperately looking for a rackmount kit for the ERLite-3 router.  I've checked everwhere for the Waveguard/KAM Fabrication mounts specifically for it, but everyone that sells it is out of stock and...

View Article
Browsing all 20028 articles
Browse latest View live


<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>