EdgeRouter X WAN Interface DHCP
Hi all, I just got the EdgeRouter X and I'm trying to replace my rented Comcast all-in-one with a TP-Link TC-7610 Cable Modem, Ubiquiti EdgeRouter X, and Ubiquiti UAP-AC-LITE. But I'm having trouble...
View ArticleClik here to view.
Can't seem to get L2TP VPN working over PPPoE (the server did not respond)
I've been trying different things with this for a full day now, probably time to ask for help I'm on an ADSL connection so I have a Netcomm router bridged to the X-SFP. The ISP dynamically assigns...
View ArticleER-X, ERlite-3, ERPro-8 comparison table, and Tomato
I have been looking for a good comparison table of the different EdgeMAX routers and didn't find one. So I made a comparison table of my own - is it accurate? Ubiquiti...
View ArticleedgeOS1.9 DHCPv6 static lease configuration
I want to allocate fixed IPv6 address to some of my systems and can not find a way to make it work. dynamic ipv6 allocation works OK but unable to get the static allocation to work. $ show service...
View ArticlePPTP connects but WAN is lost once it does
Just got an ERL and I've setup PPTP using local users instead of radius.My PPTP IP range is 192.168.0.240 to 192.158.0.250Can connect from a remote Windows 10 PC via PPTP perfectly.Once connected, I...
View ArticleClik here to view.
Network level ad blocking!
I have a really slow Comcast connection at home, 10Mbps or slower, so I knew that this wouldn't really show much of the ER-X router's potential... but just for kicks, I decided to run speedtest.com on...
View ArticleUnable to get two IPSEC VPNs up at the same time.
The goal is to get two IPSEC VPN sites operational simultaneously from one Edge-lite router. I can get one or the other, but not both up at the same time. All configuration has been done via the CLI....
View ArticleQoS HFQ problem with download
Hello, i have a problem with my Edgerouter X SFP. I have a PPPoE connection with a Public IP and a /27 Public Subnet that is routet to the PPPoE IP.The Routing is without NAT.The Routing and Firewall...
View ArticleEdgerouter X SFP dead after upgrade
Hi, I have just gotten a Edgerouter X SFP and the first I did was to upgrade it to version 1.9 using the ER-e50.v1.9.0.4901118.tar file. But after the router rebooted is it not possible for me to get...
View ArticleDual WAN routing but not load balanced
Hi there! I'm hoping somebody can assist me with my setup. I have an EdgeRouter Lite 3-Port running firmware 1.9.0I have 2 WAN links (eth0, eth1) and one link to the LAN switch (eth2) On the LAN side I...
View ArticleOpenVPN and MTU ?
I have heard that by using OpenVPN is should be possible to have an MTU of 1500 on both ends og the tunnel, and OpenVPN splits the packet and reassemble it again ? I need to preserve a packet size of...
View ArticleQuestions about EdgeRouter Lite before buy
Hello.Currently I'am using VPN as client on Mikrotik RB2011UiAS-2HnD-IN, it's giving me speed 23 mb/s downloading and 20 mb/s uploading on old firmware, new firmware give 16/20. I think to replace it...
View ArticleDHCP server for each port on EdgeRouter PoE
I configured the interfaces as follows:interfaces { ethernet eth0 { address 192.168.1.1/24 duplex auto poe { output off } speed auto } ethernet eth1 { address dhcp description wan duplex auto firewall...
View ArticleER-X with 105 static routes needs 5min to start ... Were are the network...
HelloI have my whole network with static routes with some linux boxes as routers.Now I'm migration to UBNT Routers ER-XI have about 105 static routes.If using router os commands to se route set...
View ArticleAllow VLAN to VLAN / Subnet to Subnet?
Edge Router X: eth0 is WAN eth1-4 are on swtich0 switch0 has VLANs 1-5WAN_IN eth0/in and WAN_LOCAL eth0/local firewall from wizardI'd like to have VLANs 2,3,5 be able to communicate with one another...
View ArticleEdgeRouter Lite - Need to stop routing between Eth1 and Eth2
I replaced a flaky Netgear router with an EdgeRouter Lite...pretty simple... I used the WAN 2LAN2 Wizard and got it setup pretty quickly. My Eth2 port is for a guest network (192.168.4.x). How can I...
View ArticlePlease help me choose SOHO equipment (USG/ER/Other ?)
Hi,I recently got ERL and UniFI AP LR , now I'm trying to figure out how to extend furteher my SOHO network.Actually, I've some Mikrotik experience, but can't match Ubnt/Mkt model lines. I'm looking...
View ArticleWARNING: REMOTE HOST IDENTIFICATION HAS CHANGED
Hello everyone,I have tried to use Terminal and SSH to the EdgeRouter.Then I have this message: WARNING: REMOTE HOST IDENTIFICATION HAS CHANGEDIT IS POSSIBLE THAT SOMEONE IS DOING SOMETHING...
View Articlecan't connect to EdgeRouter via dhcp after wizard setup
The only time I can ping the edgerouter is with a clean config. I cp /opt/vyatta/etc/config.boot.default /config/config.boot then reboot. Set my laptop (running Linux Mint 17.3) to FixedIP at...
View Articlesecurity camaras problem connecting remotely setting
good morning im having alot of problems setting up the port fowarding on my edge router x everything else works i just can connect to my securty camara i put al the same settings from my old router...
View Article