Hello,
I'v been banging my head on this for about a week now and i cant seem to get it to configure the vlans.
here is how im trying to do the setup
Cable Setup
eth0 WAN
eth1 Core network Switch Running Vlans 2 and 3 (also has 42 but the mPort is moving to the router.
eth2 UniFi AP
eth3 mFi Mport
eth4 LocoM5 (Bridge to other UniFi AP)
VLan setup
2 Core Network
3 Guest Network
42 mFi Network
eth0 None
eth1 PVid 2 , Tag 3, Tag 42
eth2 PVid 2 , Tag 3, Tag 42
eth3 PVid 42
eth4 PVid 2 , Tag 42
IP setup
192.168.0.254 Router IP Vlan2
No DHCP
No IP set for Vlan3 use needs to pass the data AT&T RG handles the dhcp
192.168.2.254 Router 2nd IP Vlan 42
DHCP Range 192.168.2.1-192.168.2.200
I used the wizard and did the wan+2lan2 and bridge the eth1 interface to eth 2-4.
normaly routers dont kick my butt but good lord this one is 