Hi all!
I’m (fairly) new to ubiquity product but nonetheless very enthusiastic about the products. I started out with a few Unifi products for some clients to a current configuration with a EgeRouter Pro and 48 Port EdgeSwitch and more. This is where my question is all about.
What I want to achieve is the following:
Eth0 & Eth1 as WAN for load balancing
Eth2 as LAN for the internal network
Eth3 as a third WAN for the VoIP network only.
Eth0 is connect to a ADSL line with PPPoE (Draytek vigor 130). At the moment the load balancing configuration is working with 1 ADSL connected. The second is to be installed by the ISP next week.
On the EdgeRouter I have created the following VLAN’s on Eth2:
VLAN1 = 192.168.1.0/24 - Management network (Default)
VLAN5 = 192.168.5.0/24 - VoIP network
VLAN10 = 192.168.10.0/24 – Local network
VLAN20 = 192.168.20.0/24 – Test network
VLAN30 = 192.168.30.0/24 – Guest network
The VLAN’s are working and passed through to the EdgeSwitch. I have verified that each VLAN is working and has access to the internet. VLAN10, VLAN20 & VLAN30 are also passed through to a AC Pro for the Wi-Fi networks.
My big question is in the third WAN interface. I have read some topics which explain how to route specific traffic (like HTTPS) over a specific interface. In my case I want to use Eth3 (PPPoE) exclusively for VLAN 5 while still being able to communicate with VLAN 5 from the VLAN1 and VLAN10. Is there any way to configure this?
I have looked at this thread: https://help.ubnt.com/hc/en-us/articles/204952274-EdgeMAX-Policy-based-routing-source-address-based- about policy based firewall however am not confident enough to just try something in the CLI since the setup in the that topic is different from mine. So far I managed to configure the L2TP VPN function on a few ER-Lite’s but that is all the experience I have with CLI so far. I looked through all the GUI option and I am hoping somebody can help me to achieve this via the GUI
