Duplicate IPv6 address for interface in GUI after upgrade to 1.8.5

I recently (hah!) upgraded my ERL3 from 1.8.0 to 1.8.5. The GUI is now showing an extra (and redundant) IPv6 address for eth0. Previously, only my /128 was shown in the GUI.

Here is what the CLI says about my interfaces:

ubnt@ubnt:~$ show interfaces
Codes: S - State, L - Link, u - Up, D - Down, A - Admin Down
Interface    IP Address                        S/L  Description                 
---------    ----------                        ---  -----------                 
eth0         192.168.1.1/24                    u/D  Management interface        <Comcast /60 prefix site 2>::1/64         
             fd1f:1009:6958::1/64             
eth1         192.168.9.1/24                    u/u  Home LAN           <Comcast /60 prefix site 1>::1/64         
             fd1f:1009:6958:1::1/64           
eth2         <re.da.ct.ed>/22                    u/u  Comcast XFINITY WAN         <r:e:d:a:c:t:e:d>/128
lo           127.0.0.1/8                       u/u                              
             ::1/128                          
vtun0        10.9.1.1/24                       u/u  Home VPN  

Notice the ULAs on eth0 and eth1. In the GUI, eth1 displays correctly, but eth0 is showing two versions of its address:

fd1f:1009:6958::1/64
fd1f:1009:6958:0::1/64

Thoughts?