Hey guys maybe you can offer some advice on an issue I'm having with a BT (UK) Infinity (FTTC) connection that has multiple IP's and on previous router was just set with PPPoE account and static address.
On the Ubiquiti I have the PPPoE setup with correct credentials but it negotiates a generic BT public address and I cannot seem to statically set the required IP on the pppoe 0 account.
After messing around for a bit I have set the IP address on the eth0 interface and can access inbound on the address but for outbound traffic the source shows as the generic pppoe 0 session address. It does not seem to work when I change NAT from pppoe to eth0.
Can anyone offer any advice on how I can get this working as expected.
Thanks
