Trying to setup a erpro8 but am not having much luck . I have the router connected to a edgswitch 24 which i had no problems configuring but the router is a bit advanced for someone who has only setup consumer grade routers .
SOHO config . No problem getting a connection to my isp via ppoe dsl but cant get the ports configured correctly so all my networked devices communicate .
All my devices , cams , nas & computers all have static ip in the 10.0.1.x ip range .
Is it possible to setup the router so all ports are in the same 10.0.1.x ip range & subnet for all router ports ?
Set 0eth port to 10.0.1.2 & 2eth port to 10.0.1.4 address's but only 1 or the other will route traffic not both at the same time .
I know it probably a easy fix but never ran into this with off the shelf routers .
Guessing that i need to set one of the ports to a diffrent ip or subnet but not sure exactly how it needs to be configured so that all my devices on my network talk without changing the ip address of all my devices .
Spent about 7hrs trying to get it working and am about ready to give up .