This is my 1st attempt on getting the router up and going.
Following support's recommendation, I have configured the following;
Eth0 is configured and working as my WAN and is connected to my ISP.
Eth1 is configured as my private lan with DHCP currently working, I have a downline switch connected which is working fine. (172.16.0.0)
I have 3 Unifi Access points that I need to get working with this new router.
Support had me configure Eth2 with a another private subnet (172.16.0.1), but I have 3 access points.
How do I configure eth2,eth3, and eth4 for my 3 access points???
Also, none of my wireless devices (eth2) can communicate with devices (like printers) on eth1.
Any ideas???
Thanks,
Joel