I'm tryign to setup an EdgeRouter Pro that is connected to an existing firewall. Here is my current setup that is fairly basic for testing.
Firewall Interface: 10.1.0.1
ERPro
eth0 (LAN) 172.30.200.254/24
eth3 (to firewall) 10.1.0.2
I did not select any configuration wizards when starting, so firewall is off, nat if off and there are no rulesets set.
I've added route set protocols static route 0.0.0.0/0 next-hop 10.1.0.1
From the CLI I can ping 172.30.200.254, 10.1.0.2 and 10.1.0.1
When I plug eth0 into a switch with my laptop and configure my laptop for IP: 172.30.200.10 SM: 255.255.255.0 GW: 172.30.200.254 I can ping 172.30.200.254 and 10.1.0.1 but I can't get to 10.1.0.2.
I've checked the firewall route and rules and they are all in place, but I can't figure out what I'm missing here.
I'm still learning more about advanced networking, so any help would be greatly appreciated.
On a side note, if I physically route the cables for the firewall <-> ERPro through the same switch, it works and I can get to 10.1.0.2 and out to the net.