Every Time
i have a power blip on our hydro lines we end up with an issue of the Edge Router not booting.
unless i manually disconnect and re-connect all port cables after 5 minutes of it being booted. then and only then do i get anything from the unit.
is there a problem with these units. when the ports are bridged?
i have eth-0 set for modem input, and eth1-eth4 set for Switched/ bridged ports.
as i have them all feeding out to devices and it is just easier to set it this way.
looking for any help anyone may have, as i assume i cannot be the only one having this issue.
thank you.
