Hi folks - I am new to the ER and haven't got my head around CLI yet, so be patient! I have two routers in use, the new ER-L (A) (replacing an old box) and one with a legacy VPN in place (B).
When a device uses the B router as the gateway the box at the other end of the tunnel is reachable. On the old box a static route was in place to push traffic to the VPN which worked fine.
When a device uses the A router as the gateway, the same settings (entered via the GUI) for the static route aren't followed - a tracert show that packets are heading straight out over the WAN.
Can you suggest where I should be looking to troubleshoot this? Keen to get it going so I have some breathing room to get up to speed with the new toy.
Cheers!
