Appologies for the likely very basic question, I'm still learning.
My setup includes a EdgeRouter x with the cable modem in eth0, my pc on eth1 and eth2 connects to my Linksys router with dhcp turned off for the wifi. The wifi router has some added connections to ethernet over power but that's not really relevant. I used one of the wizzards to
What I want to do is limit the traffic on eth2 only. The part I'm a little confused on, the gui only seems to show tx or rx from the eth0 (internet) or switch0 - which all of my interfaces are part of? I still want my desktop to get full up/down, but any devices over wifi or poe to be limited upload (background backups).
Can anyone help point me in the right direction on what I would need to do to do this? I tried the EdgeOS gui to limi twith the QoS tab, but that seems to be limiting everything.
https://help.ubnt.com/hc/en-us/articles/216787288-EdgeMAX-Quality-of-Service-QoS-
for this article, do I need to change how things are configured - I can try the suggestion for the cli to limit eth2 but since the gui doesn't show any traffic on eth2 I wasn't sure if I need to start somewhere else
I used the wizzard to set this up, and haven't modified anything since
Thanks!