I just upgraded my ERL to 1.9.0 from 1.8.0 this morning and ran into a few problems. My firewall rules didn't transfer, and then the router refused to respond when I added them back so I had to factory reset. After that I uploaded the 1.8.0 config I saved this morning before upgrading but it didn't work correctly, so I have to rewrite my firewall rules. I only have a few so it wan't take too long, but still...
See the attached photo. I've circled the items of interest:
- eth1 shows unlit (e.g. not green) in the GUI dashboard but works fine. The DHCP server is working, the Internet works fine, etc.
- In the same photo are the results of the 'show interfaces' command using putty, which are correct. eth0 is Internet, eth1 is LAN1 (in use) and eth2 is LAN2 (active but not connected).
- LAN1 isn't available as an interface, & I therefore can't apply firewall rules.
I've gone through the forums here but can't find a similar problem. Is there something I missed in the upgrade, and why is there a mismatch between the GUI and the 'show interfaces' command?
Using Chrome Version 53.0.2785.143 m (64-bit). Same problem with Firefox version 47.0.1.