I am trying to figure out where to start with my setup then actually get all of this dream into reality. Problem is there is ton's of information, limited GUI, and I don't even know what VPN option is the best way to go or if my setup needs to be altered. I have noticed many incomplete threads and several where the information is just too old to be certain it even applies.
EdgeRouter Pro 1 - Open VPN Site To Site to Router 2 (Preferably Load Balanced ISP2+1 with failover either way)
Eth0 ISP1 Cable 150 Mbit down/20 Mbit up - Load Balanced with ISP2
- Primary for Internet Use
Eth1 ISP2 FIber 50mbit down/50mbit up - Load Balanced with ISP1
- VPN Users Eth0 or Eth1
- 40 Mbit down/up For use by Business and VPN users (Eth3)
- 5 Mbit down/up For Use by VoIP (Eth4)
- 5 Mbit down/up For Use by Public WiFi (Eth5)
Eth2 ISP3 4g - Last ditch failover if ISP1 and ISP2 are down. (VPN Failover would be nice but VoIP and internet would be good)
Eth3 LAN Business 192.168.1.0
Eth4 LAN VOiP 172.16.1.0
- 5mbit down/up via ETH1 (Failover to Eth0 then Eth3)
Eth5 VLAN'd (planning on VLAN at Switch) Public WiFi (UniFi AP's) 10.10.10.0
- 5mbit down/up via ETH1 (no failover)
EdgeRouter Pro 2 - Open VPN Site To Site to Router 1
Eth0 ISP1 Cable 250mbit down/30mbit up - Not Load Balanced but Failover VPN with Eth2
Eth1 ISP2 Hold Future Fiber Link
Eth2 ISP3 4g - Last ditch failover if ISP1 and ISP2 are down.
Eth3 LAN Business 192.168.2.0
- 250mbit down/25mbit up
Eth4 LAN VoIP 172.16.2.0
- 5mbit down/up via Eth1
- Failover to Eth2
Eth5 VLAN Public WiFi (UniFi AP's) 10.10.20.0
- 5mbit down/1mbit up via Eth1 (no failover)