Hi,
To keep it short, I have an ERLite-3 with a PPTP tunnel client for special traffic. Since routing all traffic through it would be undesirable, only hosts connected to an internal L2TP VPN are NATed and routed through the PPTP tunnel to a remote site, while the rest of hosts are NATed and routed through WAN. Everything works fine but now the PPTP server on the remote site has been updated to IPv6, is it possible to enable NAT64 and to route the IPv4 clients connected to L2TP server through the PPTP client? What would be the main steps required to achieve that? I've tried to define an IPv6 route but I think that also something should be done to achieve NATing of the L2TP clients, which I don't know if it's possible, since all I've seen around talks about NAT66. If NAT64 were impossible in this scenario, what setup could I put in place to achieve the same behaviour as I was getting prior to the IPv6 update?
Thanks all in advance, and best regards.