Hello,
I noticed after upgrading my ER-POE to v1.9.0 that my default route (which is set via PPPoE) does not appear in the Routing section of the GUI. My other routes are all there - only the default route is missing. As I recall, it used to be listed as a "kernel" route in previous software versions.
It is also missing using the show ip route command. However, using show ip route forward (which shows the kernel route table), the default route is present as expected. This seems to be a display issue only, since routing via the default route is working fine as before.
Was there a change made in v1.9.0 to no longer display kernel routes in the GUI (or show ip route)? If so, this would explain why the default route is missing.
Another (separate) route display issue is that my openvpn server interface vtun0, which is assigned a private /24 subnet, has a route entry of "0.0.0.0/24" which I find strange (I would expect to see the actual private subnet instead). Again, this seems to be a display issue only since routing via the VPN works fine as before.
Thanks
cinergi
