I have a very basic setup with an ER-X (1.8.5) and UAP-AC-Lite:
ER-X Port 0: WAN in
ER-X Port 4: Unifi UAP-AC-LITE via a POE adapter
--- (so AP is not powered POE through ER-X; ERX is also on own power)
While it's 99% stable, if I lose power and both units reboot, the AP appears to boot faster than the ER-X and is left in an uncertain state. If I manually reboot the AP (or pull the ethernet and plug it back in) then all is good. I'm not sure if this is due to DHCP provisioning or somethign else. All I know is that the AP has to wait a bit for the ER-X to settle before it can start up.
Is there a way to delay the startup of the AP on port 4 - for example, for it to wait 30 seconds until after the ER-X boots?
I looked at the PoE watchdog and it looked good except: 1) I don't really have any stable devices on the other side of the AP that could take the pings; 2) The AP isn't powered through PoE through the ER-X.
Thanks in advance.