Preface: I am a relative newby to EdgeOS
I have set up my ER-X with an ADSL account using the PPPOE setting on the WAN interface (eth0) bridged to my ADSL modem. I have port forwards set and configured VLANS for guest access and IoTs devices.
I have now had a cable service installed. I wish to bridge the cable modem and use the ER-X.
I have tried deleting the pppoe interface and resetting the WAN interface (eth0) to DHCP but I cannot access the internet after doing this. This attempted change was from the web interface.
I have tried pinging 8.8.8.8 and several other ip addresses from the Toolbox and get no response.
The WAN interface (eth0) appears to get an ip address from the cable provider.
The current eth0 config is as follows.
interfaces {
ethernet eth0 {
description "Internet (PPPoE)"
duplex auto
pppoe 0 {
default-route auto
firewall {
in {
name WAN_IN
}
local {
name WAN_LOCAL
}
}
mtu 1492
name-server auto
password xxxxxxxx
user-id xxxxxxxxxx@xxx.xxxxxx.com.au
}
speed auto
}
How do I go about changing the eth0 from PPPOE to DHCP?
Thanks in advance.