First off, I am new here and a newbie with this router.
I finally had it with comsumer router/modems. Currently have a Netgear D6200 connected to DSL line. Am having all kinds of problems and so from recommendations on another forum decided to try the Ubiquite line.
I have watched some videos and read a lot, but am stuck at a very basic point. I installed firmware 8.5, and used the wizard to use eth0 for WAN and brideged 1 through 4.
I set the Netgear for Modem only. However I cannot get an internet connection. Does not show an Internet IP. Can someone point me to a step by step document for this setup?
ERpoe-5
Netgear D6200
Set up in Modem Mode
CenturyLink DLS service
Thanks for any input.
George_M