Hello Ubiquiti,
I have an EdgeRouter Lite that was set up for the longest time with 2 ISP's connected thru the Load Balancing Wizard. Everything was working fine until I got new software that requires a static IP. I went to change the Static IP and followed the directions to change it for each ISP(eth0 and eth1).
After I saved my configuration and rebooted the router, I tried to login to ensure that each connection was done properly, but the username and password were no longer saved on the router. I found that I can relog in using the default admin login ubnt/ubnt, but I'm still unable to find my old user info and login with that.
What's interesting is that all my configurations are still there(static IP leases for each computer, fax, networking device, etc.), but I don't know what's working as far as my static info. That all got erased and I don't know if anything is static now. I still have internet access so one of the configs is still valid.
I'm trying to find out if anyone else has ran into a problem like this or if someone could help walk me out of it.
Once again I have 2 ISP connections into my EdgeRouter Lite that were configured into eth0 and eth1. Output is on eth2 to my EdgeSwitch where I route everything from there to all my devices.
I have the static IP info for each ISP still, I just need someone that may have done this before to help me out.
Thanks for the help,
Jared