Hello,
I recently purchased and setup a EdgeMax Light for my SOHO setup. I ran through the wizard setting my LAN up as a WAN+2LAN2. The configuration is as follows:
eth0 - WAN - DSL
eth1 - 192.168.1.* Netgear gigabit unmanaged switch - wired devices connected to switch
eth2 - 192.168.2.* Asus RT-N66U w/ Sabai (Tomato) OS now setup as the wireless access point
My Poineer SC-71 network enabled reciever (with built in Airplay) is wired into the Netgear switch on eth1. The iPhones, iPads and laptops are accessing the Asus AP on eth2. I can get the iPhones & iPads to connect to the receiver via the Pioneer App by putting it's eth1 IP address in. Airplay will not show up on the i-devices though. I'm assuming because the reciever is on eth1??
Assuming this is the issue, is there a way to have the wireless devices display Airplay which is on eth1?
If possible I would like to do this without checking off the bridge funtion on the EdgeMax. I also realize I could plug the Pioneer into one of the Asus gigabit ports and run it off eth2 but would prefer if possible to keep the setup the way it currently is.