I have an ERX that was configured with all ports on switch0 and POE-Passthrough is enabled. Basically functioning as a POE-Passthrough 5-port switch.
The ERX is powered by a ES-24-250, and there is a Unifi AC-LR plugged into the passthrough on the ERX.
ES-24-250 > ERX > Unifi AC-LR
For some reason the ERX has stopped passing all traffic. The POE-Passthrough is still working because the AP is in an "isolated" state. No traffic can pass through the switch. It had been functioning fine for 20 days. (I am positive configs had been saved, the device was rebooted when it was finally installed.)
This has now happened twice. Both were running EdgeOS 1.8
The first time it happened, I swapped out the ERX for the client. I was able to recover the ERX by factory reseting it, and then going through setup again. Before factory reseting, the ERX would not respond on its' assigned IP or the factory default IP.
Now that a second ERX has failed like this after only 20 days, does anyone have any suggestions? I need to swap it again, but also don't really want to tell the client, "oh it happens sometimes".
Thanks,