Model Edgerouter POE
eth0 --> Cable Modem
eth1 --> UnifiACPRO
eth2,3,4 --> Switch0
The system was setup with the wizard.
On the dashboard no IP address is displayed for eth2,3,4 its states TBD
I attached a NAS to eth2 but I am not able to connect to via wireless as it does not have an IP address. Even the provided discovery tool does not work
Under ACTIONS I see No address is checked for eth2,3,4
What do I use to assign an IP address so I can access the device attached to that port. I prefer a static address so the NAS drives have fixed IP address so they can mount easily.
I set use used DHCP under the switch0 instead of manual IP address and this caused all sorts of collisions on the wireless and wired networks, so I put that back to manual.