Just picked up an edgerouter x sfp.... gig SFP installed...replaced an Asus wireless router. I have internet access via cable modem - Speedtest with Asus peaks at just over 200mbps. After connecting Edgerouter to same modem - can never achieve anywhere near that speed - maybe 30mpbs. I'll admit I just used the WAN+2LAN2 wizard choosing eth5, DHCP, Enable Default Firewall, One LAN....only configuration change i made was hwnat enabled. Any ideas on what is causing this? Here's my current config:
show configuration
firewall {
all-ping enable
broadcast-ping disable
ipv6-receive-redirects disable
ipv6-src-route disable
ip-src-route disable
log-martians enable
name WAN_IN {
default-action drop
description "WAN to internal"
rule 10 {
action accept
description "Allow established/related"
state {
established enable
related enable
}
}
rule 20 {
action drop
description "Drop invalid state"
state {
invalid enable
}
}
}
name WAN_LOCAL {
default-action drop
description "WAN to router"
rule 10 {
action accept
description "Allow established/related"
state {
established enable
related enable
}
}
rule 20 {
action drop
description "Drop invalid state"
state {
invalid enable
}
}
}
receive-redirects disable
send-redirects enable
source-validation disable
syn-cookies enable
}
interfaces {
ethernet eth0 {
description Local
duplex auto
speed auto
}
ethernet eth1 {
description Local
duplex auto
speed auto
}
ethernet eth2 {
description Local
duplex auto
speed auto
}
ethernet eth3 {
description Local
duplex auto
speed auto
}
ethernet eth4 {
description Local
duplex auto
speed auto
}
ethernet eth5 {
address dhcp
description Internet
duplex auto
firewall {
in {
name WAN_IN
}
local {
name WAN_LOCAL
}
}
speed auto
}
loopback lo {
}
switch switch0 {
address 192.168.1.1/24
description Local
mtu 1500
switch-port {
interface eth0 {
}
interface eth1 {
}
interface eth2 {
}
interface eth3 {
}
interface eth4 {
}
vlan-aware disable
}
}
}
service {
dhcp-server {
disabled false
hostfile-update disable
shared-network-name LAN {
authoritative enable
subnet 192.168.1.0/24 {
default-router 192.168.1.1
dns-server 192.168.1.1
lease 86400
start 192.168.1.38 {
stop 192.168.1.243
}
}
}
use-dnsmasq disable
}
dns {
dynamic {
interface eth5 {
service custom-noip {
host-name **********
login *******
password ****************
protocol noip
server dynupdate.no-ip.com
}
}
}
forwarding {
cache-size 150
listen-on switch0
}
}
gui {
http-port 80
https-port 443
older-ciphers enable
}
nat {
rule 5010 {
description "masquerade for WAN"
outbound-interface eth5
type masquerade
}
}
ssh {
port 22
protocol-version v2
}
}
system {
host-name ubnt
login {
user admin {
authentication {
encrypted-password ****************
plaintext-password ****************
}
level admin
}
}
ntp {
server 0.ubnt.pool.ntp.org {
}
server 1.ubnt.pool.ntp.org {
}
server 2.ubnt.pool.ntp.org {
}
server 3.ubnt.pool.ntp.org {
}
}
offload {
hwnat enable
}
syslog {
global {
facility all {
level notice
}
facility protocols {
level debug
}
}
}
time-zone UTC
}