I jsut recently overhauled my entire home and vacation cabin networks with EdgeRouter Light's at each site (with v1.9.0 firmware) and a AP-AC Light wifi for the home and a Rocket M2 with a 10db omni for the vacation cabin. Everything is tied together with NetGear GS108T switches.
Previously I had a VPN between the two going with my Asus router running OpenVPN and while it wasn't much, it was a help being able transfer files around if I had to.
So my intent with this upgrade was to setup a IPSEC VPN from the house to the vacation cabin.
I have both of them setup and running EXCEPT the IPSEC VPN, I've been working for two weeks searching the web trying to figure out what could be wrong and knowing me, it's probably something simple I've overlooked.
Setup is as follows....
nwh (home):
eth0 : 71.46.79.90
eth1 :10.1.1.1/24 (lan)
eth2 : 10.2.1.1/24 (wifi network, AP-AC Light)
wth (vacation cabin)::
eth0 : 75.103.181.28
eth1 : 10.2.1.1/24 (lan)
eth2 : 10.2.2.1/24 (wifi network, Rocket M2)
Bot ERL's are setup for dyndns, but for now I have hardwired their IP addresses into the VPN to make sure I can get that going first before I start breaking other things with the dyndns issues.
So far, I haven't been able to get the VPN to go up and attached are copies of the config files for each (hopefully I didn't botch them with I cleaned them up). I've configured the VPN via the GUI but I'm not afraig to go to get my hands dirty with the CLI to get this fixed.
I would appreciate any help with helping diagnose this and getting it fixed as I really need the VPN going as I work from home and having a VPN back to the house when I'm at the vacation cabin really helps.