Hello all,
New user of Ubiquiti equipment and so far I am loving it. I can usually figure everything out on the router that I need, and what I can't is often handled by the forums/community. However, I've looked all over, and I can't find the answer I need, so I made a profile and am asking for help.
I have a user who needs to have a single port open to an entire subnet, not just forwarded to one IP address. Can someone show my how to do this?
Setup is currently an ER-Pro on 1.9 Firmware, WAN on eth0, LAN on eth2 configured with WAN + 2LAN2 wizard.
Thank you in advance for your help!