EDIT: Read my post later in the thread for an explanation of how I undid my mistake
I have a new ERPRO-8 for a client install that was suppose to be this morning. Its now hopefully going to be Friday morning.
Configuration that was done:
ETH0: Configured with clients static IP
Firewall rules: Whitelisted external management IP's to WAN port
ETH1: DHCP 192.168.1.1/24
ETH2: DHCP 192.168.2.1/24
Firewall rules:
Where I f*cked up:
I dont clearly remember what I did. I created firewall rule sets applied to ETH1 and ETH2 for blocking P2P traffic but ended up blocking all LOCAL data over those ports. DHCP IP's aren't even assigned.
Questions:
1) Is there a way for me to spoof one of the external whitelisted IP's to gain access over ETH0 and undue my idiocy?
2) Is there some other simple way to undue this? Ports 3-7 are not configured for any pass-through, some I'm stuck with the above.
3) I guess this is the last resort option: https://help.ubnt.com/hc/en-us/articles/204959514-EdgeMAX-Last-resort-recovery-of-failed-EdgeOS-device
TLDR: I'm an idiot and why not to configure network equipment at 2am when you're falling asleep