Current situation uses 2 routers, I would like to replace them both with one Edgemax 8 Pro.
Current configuration router 1:
WAN: Point 2 Point ip connection with a /30 subnet (xxx.xxx.xxx.106/30 to xxx.xxx.xxx.105)
LAN: /29 subnet of real IP`s (yyy.yyy.yyy.10) (Range= yyy.yyy.yyy.8-15)
Current configuration router 2:
WAN: yyy.yyy.yyy.11, gateway yyy.yyy.yyy.9
LAN: 192.168.1.254/24
I configured the edgerouter with the loadbalance wizard, to have a fallback internet connection on eth1.
I configured eth0 with the ip of router 2: yyy.yyy.yyy.10
Is it possible to bridge eth4 and eth 5, configure them with the ip of router 1? (xxx.xxx.xxx.106/30 to xxx.xxx.xxx.105) and connect the fiber wan connection in eth4, patch eth5 to eth0?
And use a routing table or policy to route all traffic from eth0 through br0?
Any suggestions to route the traffic through a Point 2 point connection in the same router?
I am trying a lot of differtent configurations, so please dont`t scream "Post config!" ;-)