I have a new ERPoE 5 and am trying to set it up for my home. Ive looked through posts for the past hour and have not found much that matches my situation that I understand.
I am trying to setup:
eth0: WAN (ip assigned by cable isp)
eth1: DMZ (lamp server)
eth2: LAN (with unmanaged netgear switch attached)
eth4: UAP (its an AC-Lite)
So far I have:
Updated firmware to 1.9.
Run setup wizard.
eth0: use dhcp
eth1: static 192.168.2.1/24
eth2-4: use dhcp
eth3: disabled
switch0: dhcp server 192.168.1.1/24 for eth2-4.
Beyond this, I have no idea what to do next. I know there is a built in firewall, but I'm not sure how to implement it. I also believe I will have to forward ports to the server on eth1.
Could anyone show me how to pull this off?
Edit: I also tried using the dashboard to enable PoE on eth4, but I keep recieving an error message.
