Hello,
we try to setup the Edgerouter 8 with latest firmware (1.9) to do load balancing of three wans
eth0 (speed 5/5 Mbps)
eth1 (speed 20/5 MBps)
eth2 (speed 20/2 MBps)
eth6 (10.0.4.1/20) is "public" lan wifi Cloud Key and APs on it for hotel guests
eth7 (10.0.0.1/24) is the internal lan for hotel management
Unfortunately the connection load balanced connection is unusable (while pinging 8.8.8.8 the packet loss is around 30 %). When I unplug 2 of the three WANs it is usable, but slow.
Status shows:
ubnt@ubnt:~$ show load-balance status
Group G
interface : eth0
carrier : up
status : active
gateway : 10.2.243.73
route table : 201
weight : 11%
flows
WAN Out : 1181
WAN In : 45
Local Out : 713
interface : eth1
carrier : up
status : active
gateway : 10.2.243.81
route table : 202
weight : 44%
flows
WAN Out : 1274
WAN In : 4
Local Out : 2383
interface : eth2
carrier : up
status : active
gateway : 10.10.0.138
route table : 203
weight : 44%
flows
WAN Out : 1642
WAN In : 2
Local Out : 2566 Watchdog says:
ubnt@ubnt:~$ show load-balance watchdog Group G eth0 status: Running pings: 4 fails: 0 run fails: 0/3 route drops: 4 ping gateway: ping.ubnt.com - REACHABLE last route drop : Wed Aug 24 07:27:49 2016 last route recover: Wed Aug 24 07:56:01 2016 eth1 status: Running pings: 203 fails: 0 run fails: 0/3 route drops: 4 ping gateway: ping.ubnt.com - REACHABLE last route drop : Wed Aug 24 07:07:48 2016 last route recover: Wed Aug 24 07:22:59 2016 eth2 status: Running pings: 2231 fails: 1 run fails: 0/3 route drops: 1 ping gateway: ping.ubnt.com - REACHABLE last route drop : Wed Aug 24 01:14:34 2016 last route recover: Wed Aug 24 01:17:07 2016 ubnt@ubnt:~$
I attach the full config.
Please is here someone to help. I do not want to return the the old TP-LINK load balancer again :-(
Thank you very much
Karel