I will have:
- 1 single pppoe connection for WAN.
- local network -- probably the default management lan with erx as the only default: 10.1.1.1
- vlan3 lan - 10.1.3.0/24
- vlan2 dmz - 10.1.2.0/24
- vlan9 guest - 10.1.9.0/24
some funny stuff i dont get is:
the basic wizard only allows wan on port eth0/eth4 only.
load balancing allows on any
wan+2lan on eth1
wan+2lan2 on eth0/eth4
heres the part i dont get also. wan+2lan requires a default configuration reset. mind telling me what happens if i use basic wizard and then apply a wan+2lan configuration via load. will something weird happen? does the wizard do anything to the webui template or something?
i need to reserve eth4 for poe-out to unifi ac lite
what im hoping to do is have pppoe/wan on eth3. it makes initial configuration always easier SINCE default configuration only has an ip address set only on eth0. by configuring wan on eth0 means i need to keep swapping cables. i wish more thought was given to this.