Hi all,
So I am having an issue...
First my equipment: NVG599 (setup as close to bridgemode as possible) Using this guide: http://www.dslreports.com/faq/17734 As far as I can tell with AT&T there is no way to get rid of this. After that I have an EdgeRouterPro running version 1.8.0 (soon going to 1.8.5) however right now people are actively using so I cannot restart.
Recently I did an overhaul on my linux server at home. Things went fine and services came back up. When I put the server back online in order for me to use the server while I was on wifi locally I had to disable hairpin nat. At the time with the NVG I was thinking maybe I was double natting and things were getting goofed up.
Last night all of my services that resolve to port 80 only go to the router now. Which is kind of affecting things rather negatively.
If I renable hairpin nat again now I cannot use any services locally on the network. How do I get both to work. I mean right now the only thing affected is port 80. If I renable nat then I cannot access anything on the network. This seems strange to me. When I had comcast (just changed about a month ago) I was able to leave hairpin enabled and everything worked out fine.
I am not running anything special either... Just the wizard with defualt values for 2 networks 1 wan. Network 1 is in production, Network 2 is for later and not even built yet.
Questions comments and suggestions would be greatly appreciated. Not that it matters but I use No-IP for my dynamic dns.
Thanks a lot you guys are always super helpful!